Please not that this kit is all printed resin so it is a little different then cast resin to work with. Resin is a little harder and more fragile so care must be used in removing the supports.( Personally I have had the best results using the Tamiya Flush Cutters don't just rip off the supports like many people say as you will inevitably break the part
If any parts are warped they can be straightened with hot water few seconds and this will make the resin pliable enough to straighten out.
Before ordering PLEASE Download the instructions and look them over. CLICK FOR INSTRUCTIONS
Click Arrows to see more photos and reference.
Right Click to view Larger Image